This kit is an add-on to your existing stock forks! There is no cutting/etc involved. This is a simple bolt-on process. You can CLICK HERE TO VIEW INSTRUCTIONS
to see how simple this is!
This kit will not only lower the front of the bike by 2", but it will also stiffen up the forks thanks to an Auxiliary Spring Pack that installs inside of the fork! No need to break out a blowtorch to stiffen things up!
This kit is designed for looks and for show. That is NOT to say it does not handle well, but it is like lowering anything else, it will stiffen things up, and will make it ride a bit rougher. If you are used to riding a Ruckus or other over-sprung front fork setup, then you will actually find that this is very soft and comfortable. If you are used to riding bikes with 6" of front end suspension travel that dive when you hit the brakes, this will seem a bit hard for you. If you are looking for a racing application, where you need improved valving, etc... then this kit is not for you. There are some other fork setups available that may be better.
Now... for those that want to get a bit lower and improve the ride (to me it is VASTLY improved... i can't stand riding a stock Grom after using this kit... haha!)... Then this kit is for YOU!
This kit Features:
- 7075 Billet Machined Aluminum Fork Spacers - SUPER STRONG Aluminum
- 6061-T6 Billet Machined Aluminum Upper and Lower Spring Seats
- Special Increased Rate Zinc Plated Springs
- Stainless Steel Washers
- Can still use ANY aftermarket top-cap, including the Tyga Pre-load cap!
Top of the line everything! These have been tested extensively in several bikes, and even before the GROM actually hit the US shores!